Paging issue

[Jeff Griffith <jg...@cssi.org>]

This is likely to be a "read the directions" questions, but I'm short on time...

How do I tell a page sequence master to not produce an even number of pages? or
rather, to only produce the number of pages required by the content (and not
to worry about whether the back side of the last sheet has any content).
I'm getting a blank page that I want to suppress.

Thanks,
Jeff Griffith


---------------------------------------------------------------------
To unsubscribe, e-mail: fop-users-unsubscribe@xmlgraphics.apache.org
For additional commands, e-mail: fop-users-help@xmlgraphics.apache.org

RE: Paging issue

["Amick, Eric" <Er...@mail.house.gov>]

It sounds like a case of force-page-count and/or initial-page-number
properties not being right, but it's hard to tell without seeing the
page-sequences you're using. 


Eric Amick
Legislative Computer Systems
Office of the Clerk

-----Original Message-----
From: Jeff Griffith [mailto:jgriffith@cssi.org] 
Sent: Thursday, March 12, 2009 12:09
To: fop-users@xmlgraphics.apache.org
Subject: Paging issue

This is likely to be a "read the directions" questions, but I'm short on
time...

How do I tell a page sequence master to not produce an even number of
pages? or rather, to only produce the number of pages required by the
content (and not to worry about whether the back side of the last sheet
has any content).
I'm getting a blank page that I want to suppress.

Thanks,
Jeff Griffith


---------------------------------------------------------------------
To unsubscribe, e-mail: fop-users-unsubscribe@xmlgraphics.apache.org
For additional commands, e-mail: fop-users-help@xmlgraphics.apache.org


---------------------------------------------------------------------
To unsubscribe, e-mail: fop-users-unsubscribe@xmlgraphics.apache.org
For additional commands, e-mail: fop-users-help@xmlgraphics.apache.org