You are viewing a plain text version of this content. The canonical link for it is here.
Posted to commits@mynewt.apache.org by GitBox <gi...@apache.org> on 2019/09/06 12:55:28 UTC

[GitHub] [mynewt-core] kasjer opened a new pull request #1990: hw/mcu/da1469x: hal_flash manual mode enhanced

kasjer opened a new pull request #1990: hw/mcu/da1469x: hal_flash manual mode enhanced
URL: https://github.com/apache/mynewt-core/pull/1990
 
 
   - before returning to automode there is no need to enter quad mode
     (auto mode will use whatever is programmed in QSPIC_BURSTCMDx_REG)
   - switching to manual mode sequence of call was made:
     da1469x_qspi_mode_manual()
     da1469x_qspi_mode_single()
     now da1469x_qspi_mode_manual() will automatically switch to single mode
     and additionally it will send break sequence that should end any
     continues read mode.
     previous code sent only one byte in single mode that is not enough
     to leave dual continuous read.
   - da1469x_qspi_mode_dual() and da1469x_qspi_mode_single() now setup
     controller in requested state without sending break sequence that
     was sent when manual mode was entered.

----------------------------------------------------------------
This is an automated message from the Apache Git Service.
To respond to the message, please log on to GitHub and use the
URL above to go to the specific comment.
 
For queries about this service, please contact Infrastructure at:
users@infra.apache.org


With regards,
Apache Git Services